Directive 2014/29/EU. Simple Pressure Receptacles, Design & Compliance.
Simple receptacles for gas storage must meet strict design, construction, and testing requirements. IgeraIndustria guides on scope, essential requirements, and compliance procedures.
Simple Receptacles Directive 2014/29/EU: technical and manufacturing complexity
Simple receptacle design requires rigorous stress analysis, material qualification, and manufacturing quality control. Scope interpretation and conformity assessment complexity create compliance challenges.
500L—1000L
Volume scope. Yet boundary with larger PED equipment unclear. Scope determination affects which Directive applies.
Carbon steel
Approved material. But material certification and traceability requirements are strict.
0.5 bar minimum
Pressure threshold. Design pressure calculation and verification critical.
Category III
High-risk receptacles require notified body design evaluation.
Instant guidance on Directive 2014/29/EU compliance
Scope determination 500-1000L
Guidance on Directive requirements.
Design pressure calculations
Guidance on Directive requirements.
Material qualification and certification
Guidance on Directive requirements.
Stress analysis requirements
Guidance on Directive requirements.
Manufacturing quality procedures
Guidance on Directive requirements.
Conformity assessment procedures
Guidance on Directive requirements.
Notified body selection
Guidance on Directive requirements.
Pressure relief device requirements
Guidance on Directive requirements.
CE marking and labeling
Guidance on Directive requirements.
Frequently asked questions
What are simple receptacles under Directive 2014/29/EU?+
Simple receptacles are welded vessels for storage/transport of compressed gases at pressure >0.5 bar, volume 500L-1000L, diameter up to 1.07m. Scope limited to specific materials (carbon steel, aluminum alloy) and gases. Excludes complex equipment, medical devices, specialized industrial use.
What are the essential safety requirements?+
Design, construction, and testing per Annex I. Materials must be suitable for service. Stress analysis required. Manufacturing quality procedures. Inspection and testing protocols. Pressure relief devices required. Marking with CE mark, design pressure, test pressure.
What conformity assessment procedures apply?+
Module A (internal controls) for Categories I-II. Module B (design evaluation) + Module D (production QA) for Category III. Notified body may be required depending on category and gas type.
What technical documentation must manufacturers retain?+
Design drawings, material certificates, stress calculations, test reports, manufacturing procedures, inspection records, declaration of conformity. Retained 10 years minimum post-production.
How are simple receptacles marked and labeled?+
CE mark, design pressure (bar), test pressure, volume (liters), material, manufacturer name/address, manufacturing year. All markings must be durable and legible. Label showing applicable gas type and hazard warnings.
What corrective actions apply if non-compliance is discovered?+
Immediate notification to competent authorities, identification of affected units, corrective measures (repair, recall, withdraw). Documentation of effectiveness verification required.
Manage simple receptacles compliance. Start today.
- ✓Free trial 14 days
- ✓Directive 2014/29/EU indexed
- ✓Upload design specs
- ✓Compliance checklists